Flux A/m^2 Analysis not Working
Simulations & Solvers
2
Posts
2
Posters
411
Views
2
Watching
-
When I run simulations with Boundary Conditions set to "Dirichlet (V)" it works perfectly. However, whenever I set Boundary Conditions to "Flux" (A/m^2) instead of "Dirichlet" (V), the analysis shows any E or J results as zero. Not sure what I am doing wrong... has anyone had the same problem?
Thank you!
-
What is the error message indicated by the red triangle? Maybe the flux is negative. Did you try adjusting the limits on the colorbar?