simulation failed
-
wrote on 16 Jan 2021, 02:10 last edited by
When I used the yoon sun arm simulaiton case in the tutorial in sim4life light, I found that after create voxels, the operation failed immediately after running. Why?
-
wrote on 16 Jan 2021, 12:51 last edited by
Can you share what error you get?
-
wrote on 16 Jan 2021, 13:59 last edited by
well,first i want to use the tutorial --Yoon-sunArmStimulation from sim4life light 6.0,but when i click the run button,First, a prompt of successful project creation popped up in the lower right corner of the software, and then a prompt of simulation failure appeared. Later, I thought I imported the arm model myself and simulated it according to the tutorial, but in "Select the "Nerve_ventral_root_spinal_T1_Brachial_plexus_ulnar_right_6" from the "Yoon-sun_right_arm_trajectories" folder in the icon_multi_tree Multi-Tree | icon_multi_tree_model Model window and drag and drop it onto the first set of three point sensor settings folders. "There is a problem with this step because the file I dragged cannot be imported into the first set of three point sensor, I don’t Know what causes this.I don’t Know what causes this. I am not sure if you can understand my current difficulties. Hope to hear from you very much.
-
wrote on 16 Jan 2021, 17:36 last edited by
Have you loaded the neurons model? You know that it has been loaded successfully when you see a little lock next to it.
-
wrote on 17 Jan 2021, 01:01 last edited by
yeah , I did exactly what I was told to do
-
wrote on 21 Mar 2021, 22:31 last edited by
@daolin_qu Could you please check that you are selecting the Nerve_ventral_root_spinal_T1_Brachial_plexus_ulnar_right_6 spline entity and not the nerve itself that instead is a surface mesh entity part of the anatomical body? Thanks!