ZMT zurich med tech

Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

define source

Simulations & Solvers

2 Posts 2 Posters 884 Views 2 Watching

M Offline
M Offline
michaelsch

wrote on last edited by

#1

Hi i need to define source one positive 1000 hz other negative
and the third as reference 0
should i do
s1 =1
s2=-1
ground=0
related to AddBoundarySettings
DirichletValue
1 Reply Last reply

0
H Offline
H Offline
Habib
ZMT
wrote on last edited by

#2

Hi Michael,

Yes, this sounds reasonable. You define the frequency in the Setup settings of the simulation, and you define three boundary conditions, -1, +1, and 0V.

Best,
Habib
1 Reply Last reply

0

Hello! It looks like you're interested in this conversation, but you don't have an account yet.

Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.

With your input, this post could be even better 💗